Guide to setup site to site transfer with flashFXP

[DanielPT]

Hey all.

I ahev spend a lot of time trying to get this work.

Im using flashfxp to transfer files from a Qnap nas to my own Qnao nas.
But im running into problems.

I have forwared port 50100 - 50200 in my router.
I have checked "use passiv ports" in qnap 50100-50200.

I have checked "FXP" on both sites. Checked "DOWNLOADER (NOT PASV)" and "Uploading (PASV)"

When i transfer 1 file it is owrking.
but when transfer alot of files like small .rar files i get this:

425 "Can’t open data connection":

When i try to transfer like 25 .rar files the first meaby 5-10 files transfer but then i get this error:

Transferred: 016.mp3 2,39 MB in 0,08 seconds (31,09 MB/s)
[R] MFMT 20080910221959 016.mp3
[R] 213 Modify=20080910221959; 016.mp3
[R] MLST 017.mp3
[R] 550 '017.mp3' cannot be listed
[R] PASV
[R] 227 Entering Passive Mode (87x.x.x.x,221).
[L] PORT 87,x.x.x.x
[L] 200 Port command successful.
[R] STOR 017.mp3
[L] RETR 017.mp3
[L] 150 Opening data connection for 017.mp3 (3678845 bytes)
[R] 150 Opening BINARY mode data connection for 017.mp3
[R] 226 Transfer complete
[L] 226 File sent ok.
Transferred: 017.mp3 3,51 MB in 0,12 seconds (28,29 MB/s)
[R] MFMT 20080910222133 017.mp3
[R] 213 Modify=20080910222133; 017.mp3
[R] MLST 018.mp3
[R] 550 '018.mp3' cannot be listed
[R] PASV
[R] 227 Entering Passive Mode (87x.x.x.x.,182).
[L] PORT 87.x.x.x.x
[L] 200 Port command successful.
[R] STOR 018.mp3
[L] RETR 018.mp3
[L] 425 Cannot open data connection.
[L] ABOR
[L] 226 ABOR command successful.
[R] ABOR

I have tryed so meny combinations now that i think there must bee a guide or somthing to get this working.

Hope you can help me.

Just tryed RUshFTP and the same result.
Tryed from my workstation and from home same result.

Regards Daniel

[bigstar]

You may need to open more ports on your firewall as 100 may not be enough.

A new port is required for each transfer or directory listing I suspect that you're using all 100 ports before they're available for re-use again.

I would recommend increasing the port range from 100 ports to 300 ports and see if that helps.

[DanielPT]

Originally Posted by bigstar

You may need to open more ports on your firewall as 100 may not be enough.

A new port is required for each transfer or directory listing I suspect that you're using all 100 ports before they're available for re-use again.

I would recommend increasing the port range from 100 ports to 300 ports and see if that helps.

HI
Thanks for the reply.
Just tryed to open 50400-50700.

And i get 19 files then the same error:
425 "Can’t open data connection":